Off the wall project. via /r/DIY


Off the wall project.

I have a mug that was made custom for me as a going away gift, however it's more of a show piece, since it is made out of materials one would normally not drink out of (think 105mm Shell). I was looking to see if anyone knew of a way I could get it coated in a way that it was usable(it's badass and I don't want it to just be a dust collector). I have looked into epoxy resin and cup turning, and I have thought about seeing if i could get a custom ceramic insert, but I'm not sure the best approach for this.

Submitted March 22, 2021 at 10:08AM by Hulknosmash88
via reddit https://ift.tt/397Ic0a

Amazon ad

Leave a Reply

Your email address will not be published. Required fields are marked *