Help cutting iron media console via /r/DIY

Help cutting iron media console

I have this iron media console and need to make a cut out on the back to fit my audio receiver. As it is, the physical receiver fits just barely but the cabling, specifically the power cord, makes it not fit.

A round hole where the power cord connects would be ideal and perhaps the cleanest but I won’t be too picky if that can’t be done.

So what is the most straight forward tool to make this cut and what is the level of difficulty for a relative novice?


Submitted March 26, 2021 at 05:24AM by aja_ramirez
via reddit

Amazon ad

Leave a Reply

Your email address will not be published. Required fields are marked *