How would you cut a 2 mm diameter hole through a car door? via /r/DIY

on


How would you cut a 2 mm diameter hole through a car door?

It'd be like one of these only much smaller https://www.lowes.com/pd/CRAFTSMAN-7-Piece-Bi-Metal-Non-Arbored-Hole-Saw-Set/1000594041

Also I need to preserve the metal piece in the center. So basically when I'm done I should have a little circular piece of metal just a little bit smaller than the hole because the width of the blade would be removed.

Submitted May 06, 2021 at 05:16PM by Fantastic-Carpet9071
via reddit https://ift.tt/2R2JzYn

Amazon ad

Leave a Reply

Your email address will not be published. Required fields are marked *