Acrylic/plexiglass end-to-end bonding via /r/DIY

on


Acrylic/plexiglass end-to-end bonding

I'm trying to make a clear-looking sword, but don't want to have to pay hundreds of $ for a custom-length large sheet when I get get several smaller sheets for a few $. Is there a way to glue transparent acrylic/plexiglass sheets end-to-end so that you can't see a seam inside?

I've watched a lot of videos online about this, but they're always either example of opaque material, or angled joints. It would be nice to know if it's possible to make the joint seamless before I waste money trying it out.

Submitted May 10, 2021 at 07:16AM by FreakCheese
via reddit https://ift.tt/3vUiDIZ

Amazon ad

Leave a Reply

Your email address will not be published. Required fields are marked *