https://www.youtube.com/watch?v=A1IqYHKHaHc via /r/DIY https://ift.tt/3seni6H
Author: diyer
Planter Project
https://ift.tt/3dw2TWM via /r/DIY https://ift.tt/3ukiw9K
Replacing damaged exterior trim molding
Our dog did some destructive chewing and damaged what I believe is called the exterior trim molding. I would like to stop by a local hardware store and buy a replacement and take a shot at repairing it myself. Can anyone give me an idea of the type of board I should be looking for?…
Cutting full sheets of plywood.
What is the easiest method for cutting down full sheets of plywood? No matter what I try I can never seem to get a straight cut over anything 2′ or 3′ long.I’ve got an old circular saw that I’ve tried with a straight edge, I’ve tried a Kobalt foldable table saw, jig saw, and it…
Need to remove very old and shitty doorknob – think person in my house is going into my room
I need to remove a very old doorknob and replace it with one that has a deadbolt but the doorknob is total garbage and just seems like it’s stuck in the door. I had to pry pieces of the faceplate off and there don’t seem to be any bolts holding the knobs in place (there…
I Built A Rolling Tool Stand For My 300lb Drum Sander
https://ift.tt/3dxdmB8 via /r/DIY https://ift.tt/3qMvDOY
I have mould that keeps growing inside one of my small storage space. I’ve cleaned it, painted it and the situation keeps happening.
I think it might be due to condensation issue but I need to get your thoughts on what i should do? via /r/DIY https://ift.tt/3pKV2qY
The Fortress of Solitude – my 2003 Honda Odyssey build
https://ift.tt/3dwU4Ml via /r/DIY https://ift.tt/3dtXTSB
18g finishing nails for plywood ceiling
I have an 18 gauge finishing nailer and I was planning to use that, as well as some loctite fastgrab glue to attach 1/2 inch plywood to the ceiling of a cabin. The plywood is getting attached directly to the bottom of the trusses, though I have attached 2×4 cross pieces between the trusses as…
Help replacing transition laminate
My pup recently chewed through my transition laminate so it needs replacing. After doing my research, my strategy was to use a putty knife and hammer to tap into the laminate at an angle to pry it up. It partially worked and that’s when I ran into the glue that was hard stuck as well…